Ferrule Processing

Brush Machine for Camfering Processing | PM-3

Brush Machine for Camfering Processing

R processing is the equipment to carry out about the perimeter edge by the side of a ferrule V side.
2400 processings can be performed in once and it can change into SC and LC by exchange of a jig.

Moreover, inside diameter R connector processing after V processing is possible by adding a vertical mold oscillation mechanism as an option.

PDF Detail

Feature

  • 2400 processings/hour are possible.
  • Since the cheap packing material is used for a brush material, a running cost is reduced.
  • It is possible to add vertical mold drive mechanism as an option.

Technical Specification

Machine size (W×D×H) 800mm x 800mm x 1700mm
Machine weight 450kg
Operation Touch panel

Option | Consumables

Option Vertical mold oscillation mechanism addition
Phosphor bronze brush
Special diameter work set jig
Consumables Diamond powder
Grease
Equipment consumables Packing brush
Exchange the brush
Work set jig(2.5㎜/1.25mm)

Page Top